NEW QUESTION NO: 18
Click the Exhibit.


Referring to the exhibit, which set of interfaces will be registered by MVRP?
A. ge-0/1/0, ge-0/1/1, ae0, ae1
B. ge-0/0/1, ge-0/1/1, ae0, ae1
C. ge-0/0/1, ge-0/0/2, ae0, ae1
D. ge-0/1/0, ge-0/0/2, ae0, ae1
Answer: C

NEW QUESTION NO: 19
Click the Exhibit.

Referring to the exhibit, which statement is true?
A. R1 has the B bit set.
B. R1 is a backbone router.
C. R1 is an ASBR.
D. R1 is an ABR.
Answer: C

NEW QUESTION NO: 20
Which protocol is a multicast routing protocol?
A. PIM
B. OSPF
C. IS-IS
D. BGP
Answer: A

NEW QUESTION NO: 21
Click the exhibit.

Referring to the exhibit, traffic handled by the s-1 scheduler is out of profile.
Assuming bandwidth is available in this scenario, which statement is correct?
A. Traffic handled by the s-1 scheduler is serviced immediately after traffic being serviced by the s-4 scheduler.
B. Traffic handled by the s-1 scheduler is serviced immediately before traffic being serviced by the s-2 scheduler.
C. Traffic handled by the s-1 scheduler is serviced immediately before traffic being serviced by the s-4 scheduler.
D. Traffic handled by the s-1 scheduler is serviced immediately after traffic being serviced by the s-2 scheduler.
Answer: D

NEW QUESTION NO: 22
OSFP is stuck in the ExStart state.
What is a common cause of this problem?
A. MTUs do not match.
B. Jumbo frames are not enabled.
C. The DR priority is configured incorrectly.
D. IP addresses are not configured correctly.
Answer: A

NEW QUESTION NO: 23
Click the Exhibit.

Router1, in peer AS 65001, advertises routes to R2 using EBGP. R2 advertises the routes learned from R1 to R3 using IBGP. R3 is configured as a route reflector with routers R6 and R7 as clients.
Referring to the exhibit, to which routers will R3 advertise the BGP routes received from R2?
A. R4, R5, R6, R7
B. R6, R7
C. R2, R4, R5, R6, R7
D. R4, R5
Answer: A

NEW QUESTION NO: 24
Click the Exhibit.

Which AS path matches the AS path regular expression shown in the exhibit?
A. 65100 65200 21870 21870
B. 65100 65101 65200 65300 21870
C. 65100 65101 65200 21780 21780
D. 65100 52870 65200 65300
Answer: C

NEW QUESTION NO: 25
When configuring class of service, what would you use to allocate bandwidth to a forwarding class?
A. Buffer depth
B. Transmit rate
C. Bandwidth
D. Speed
Answer: B

NEW QUESTION NO: 26
Which two statements are true about OSPFv3? (Choose two.)
A. The authentication mechanisms from OSPFv2 are not present in OSPFv3.
B. OSPFv3 packets are sent using local subnet addressing.
C. OSPFv3 packets are sent using link local addressing.
D. The authentication mechanisms in OSPFv3 are the same mechanisms used in OSPFv2.
Answer: A,C

NEW QUESTION NO: 27
Click the Exhibit.

You are asked to advertise the 1.0.0.0/8 and 1.5.5.5/32 routes to your 10.254.32.2 BGP peer.
Referring to the exhibit, which configuration change would satisfy this requirement?
A. Remove the export-to- as81 policy to or longer.
B. Remove the export-to- as81 policy.
C. Remove the reject-routes policy.
D. Remove the reject-routes policy to longer.
Answer: C

NEW QUESTION NO: 28
Which protocol is used for port-level access control and authentication?
A. 802.1X
B. IPsec
C. MD5
D. AES
Answer: A